The ASKER Durometer Type E for soft rubber (low hardness), as specified by JIS K 6253-3 and ISO 48-4.
The application is the same as the standard ASKER Durometer Type C
Widely used for measuring soft rubber, sponges, and other foam elastomers, as well as rolled-threads, -films and textile windings (yarn packages).
- Standards
-
- JIS K 6253-3
- ISO 48-4
- Indication range
- 0 point – 100 point (262 degree dial scale)
- Minimum indication
- 1 point (Accuracy : ±1 point)
- Indentor Design (mm)
- Height: 2.50 5.00 Dia. Spherical
- Spring Forces [mN(g)]
-
- 0 point: 550(56)
- 100 point: 8050(821)
- Central hole of diameter of Pressure foot
- Φ5.5
- Pressure foot Dimension (mm)
- 44×18(Rectangular)
- Outer Dimension (mm)
- Approx. Width 57×Depth 30×Height 76
- Weight (g)
- 200
- Application
- soft rubber, urethane foam, rubber roller
Indentor
Height: 2.50mm Shape: Spherical
Hardness Tester Selection Chart
Our product line consists of various types of durometers applicable to specific materials as indicated in the chart above.
Type A Durometer (ASKER A type), conforming to JIS K 6253-3 is the most popular type of durometer for measuring rubber hardness.
However, verification is recommended because a significant difference is estimated to be the largest when a durometer indicates measurement values from 10 to 90 points.
For hard specimens for which Type A Durometer readings indicate more than 90 points, measurements should be undertaken using the Type D Durometer (ASKER D type). However, for soft specimens with measurements of less than 20 points, the ASKER C type or Type E Durometer (ASKER E type) should be used. The most important consideration in using durometers is to select the correct type for purposes of measurement according to the specimen.
